Stop car check oil warning

ANSWER : This light will usually come on when one of two things are happening. Either the motor is in fact low on oil or the oil pressure sending unit is not working properly and may be producing a faulty reading. I would recommend first, to check the actual oil level in the motor by using the dipstick. Be sure the oil level reaches the "full" mark. If this registers as "full" then you likely have a faulty oil pressure sending unit. I would recommend having an expert from YourMechanic come to your location to take a look at your vehicle to determine what may be causing your low oil pressure light to come on.

ANSWER : Most older cars have oil leaks. Sealing technology has just not kept up with mechanical improvements to engines so much so that leaks often kill engines rather than mechanical problems. So, it is not unexpected at all to have an, indeed many, oil leaks on a 23 year old car. Oil leaks vary hugely in terms of severity and priority of repair. Oil leaking onto a hot engine manifold is the worst case (the oil can start a fire; at best, you are left breathing oil fumes in the cabin, as the oil burns off of the manifold) while de minimus seepage of oil at the oil drain plug or oil pan gasket, while annoying and messy, if limited enough is not an emergency. Some leaks are easy to repair, while others literally require the engine to be removed just to get physical access to all the leak points. In your circumstance, if you smell burning oil, oil is probably leaking onto a hot engine part such as the exhaust manifold. A certified Mechanic, dispatched by YourMechanic right to your location, can perform an oil leak diagnostic and then let you know of your repair options and costs.

As far as the check engine light, that is not related to the oil leak(s). If you request a check engine light diagnostic, a certified mechanic from YourMechanic would use a code scanner to retrieve the specific diagnostic trouble code(s) from your car’s PCM that have caused the check engine light to illuminate. Using those codes, the appropriate individual vehicle components or sub-systems (often a sensor, circuit, and the like) are then carefully tested, based on specifications set forth in your car’s Factory Service Manual, to pinpoint the cause of the fault or the reason why the check engine light has illuminated. Once the faulty part or component is identified, it is explained to your satisfaction and the mechanic will let you know of the cost to repair. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

ANSWER : The fuel pump will not stay on if you loose oil pressure. This is why it is shutting off. The loss of oil pressure may be from bad crankshaft bearings or camshaft bearings. The engine oil pan should be removed and the oil pump needs to be checked to ensure that you put in the pick up tube seal to the pump and connected the pump to the block. Then remove at least one main bearing cap and inspect the bearings for excessive wear and crankshaft damage. If you need some help with this, consider YourMechanic, as a certified technician can help diagnose the issue with your oil pressure firsthand and help you fix it accordingly.

ANSWER : Hello. If you put too thick of an oil in the car, then you may have damaged the engine bearings but this should not have caused oil to get in to the spark plugs unless the oil got into the intake of the engine or one of the pistons rings broke. If you ran it without oil and then tried to put oil in thinking it would be okay after that, then you were not that lucky and broke or damaged all of the rings on the pistons. If you would like to have this looked over, a certified professional from YourMechanic can come to your car’s location to inspect the stalling issue and go over all of the relevant systems for a better diagnosis.

ANSWER : You might have a problem with the oil filter leaking when you rev the engine and increase the oil pressure. This can be from a collapsed oil filter media or excessive oil pressure from the engine. I recommend having the oil and filter replaced using a good quality filter and have the oil leak verified to be from the filter. Make sure to not run the engine low on oil. If you are finding you do not want to drive with the leak, a mobile technician from YourMechanic can come to your home or office, and replace both your filter, and oil.

ANSWER : Hi There,
It sounds like you may need to replace the oil cap o-ring. If you haven’t done this before there are two O-rings to replace; a small green one on the base of the filter cap stem and the large black one that seals the filter cap (which seems to be the one you are having issues with). The large O-ring sits in a small square-shaped groove that is at the base of the oil filter cap. It is very easy to not properly seat the large O-ring because the threads for the oil cap are quite large and will accept the O-ring if you are not careful. I would suggest having a professional from YourMechanic come to your location to take a look at your vehicle.

ANSWER : Hi there. The oil sensor is not incredibly difficult to replace on a 2001 Cadillac DeVille, but can be difficult to get to without a lift. This video is for a different vehicle, but the same engine as your car, so you might want to watch this to see how it’s replaced. In regards to estimated cost, it would vary based on who is completing this service. I don’t believe this is part of our mobile service offerings at the moment, but I have forwarded your request to our sales and service team to let you know if we can and what the cost would be for this service.

ANSWER : Hi, thanks for writing in. I’d be happy to try to help. It is hard to definitively diagnose what the issue is. At first it seems like a transmission issue. Automatic transmissions are rather complicated and can do strange things when they malfunction. If not an issue with the transmission, you could also have a clutch issue. Always start by checking the simple components first. Check your transmission fluid level. Make sure your transmission filter is clean and debris free. When you have the transmission pan off, you can look and see if there are any metal shavings at the bottom. There is often a small magnet at the bottom of the pan designed to gather any metal shavings for a quick diagnosis. This is a sign of more serious transmission problems. Unless you have experience with automatic transmissions, it is not recommended that major repairs be done at home. I suggest taking your car to a transmission specialist for help.