How long can I drive if the bearings in the water pump is making noise? car is not over heating and there are no leaks
the bearings in the water pump is making noise. the car is not running hot and there are no leaks. How long can I drive without replacing the water pump
My car has 106000 miles.
My car has an automatic transmission.
Experienced mechanics share their insights in answering this question :
Hi there. It’s not recommended to drive a vehicle with a damaged water pump; especially if the bearings are damaged. If the water pump fails while you are driving, it’s possible your engine will suffer serious damage.
How to Identify and Fix Common car Problems ?
Our sources include academic articles, blog posts, and personal essays from experienced mechanics :
Once you notice any sign indicating a bad wheel bearing, avoid exceeding 500 miles with that issue. A failing wheel bearing will increase your difficulty in driving. But with a high-quality wheel bearing, you can drive for another 1000 miles as per the estimate.
It`s not recommended to drive a vehicle with a damaged water pump; especially if the bearings are damaged. If the water pump fails while you are driving, it`s possible your engine will suffer serious damage.
Q: Is it safe to drive with a bad wheel bearing? A: No. It can, in fact, be very dangerous to drive if one of your bearings is worn out, especially since it may cause the wheel to stop while driving. Additionally, a damaged wheel bearing puts a lot of stress on the hub, the CV joint, and the transmission itself.
You can drive until the pump seizes, and you burn up the serpentine belt and lose your alternator and power steering, and your engine overheats to destruction. You can drive while the pump leaks coolant until the coolant level falls below the level of the impeller, and your engine overheats to destruction.
How Long Do Wheel Bearings Last? In theory, wheel bearings can last as long as the vehicle itself. However, depending on road conditions and driving habits, you can expect to replace one wheel bearing for every 150,000 miles of driving.
How long does a wheel bearing last? Wheel bearings have an average lifespan of 136,000 to 160,000 km (approximately 85,000 to 100,000 miles). This is only a rule of thumb though, the actual lifespan of a wheel bearing depends on the quality of the wheel bearing and the operating conditions.
Because it is not easily seen doesn`t mean it should be out of mind. Typically, the recommended interval for replacing the water pump is every 60,000 to 100,000 miles, depending on various factors, such as the car model, road and weather conditions, and driving behavior.
The coolant is no longer circulating properly through the car. Heating and cooling may be affected by the vehicle. The car may begin to overheat as well. It is possible to drive your vehicle without a water pump, but not good to.
If your wheel bearing fails, it can cause the wheel to stop while you are driving or possibly even to fall off. At the very least, before a wheel falls off, a failed wheel bearing can/will cause significant damage to your vehicle, so it`s very important to keep an eye on these and keep them maintained.
A pump can fill a tank with water in 2 hours. Again, With the leakage, the pipe takes 2 i.e. 7/3 hours to fill the tank. Now, According to the concept used : The rate of filling the tank by pipe along with the leakage will be 3/7.
If the bearing noise has been growing gradually, then without suggesting it is “okay” to drive 200 miles, the noise may just grow worse over that distance. If the bearing noise appeared out of nowhere, then that suggests an immediate failure potential and should be changed BEFORE a 200 mile drive.
A sure sign that your bearing has failed is vibration. If the raceway surface of the bearing becomes damaged by abrasion, the rolling elements (the balls or rollers) will bounce around on the raceway surface during operation, causing high levels of vibration.
As we said before, extreme heat can be caused by friction, and this can cause a sudden seize of the bearing, causing the wheel to get blocked at whatever speed we are driving at that moment. There is a risk of an accident if we don`t take care of this issue.
One of the most alarming and noticeable signs of bad wheel bearings are brake issues, which can occur when your wheel bearings are worn down and loose in the housing. You may notice inefficient braking on the road, brake “slips,” or uneven wear on your brake pads.
the noises may also get louder when you make a turn. scraping or clicking noises can sometimes be heard at low speeds. if the noises come and go when transitioning to different road surfaces, then the issue is likely from the tires and not the wheel bearings.
Bad wheel bearings can cause the steering wheel to vibrate. The intensity increases as the vehicle speed increases and the vehicle turns to the left or right. However, the vibration could be linked to an out-of-round tire (there could be a flat spot on the tire) or a tire that is no longer balanced.
Relevant Questions and Answers :
the most relevant questions and answers related to your specific issue
How long can I drive if the bearings in the water pump is making noise? car is not over heating and there are no leaks
ANSWER : Hi there. It’s not recommended to drive a vehicle with a damaged water pump; especially if the bearings are damaged. If the water pump fails while you are driving, it’s possible your engine will suffer serious damage.
Replaced water pump (no noise before just leaky) now there’s loud humming noise and I don’t have heat. Haven’t tried driving yet.
ANSWER : Hi there. From the description you have provided, you replacing the water pump and now you have a new noise and no heat, are an combination of things going on. First, the loud humming noise coming from the water pump/timing area concerns me. Assuming, you followed the repair procedure properly for the water pump replacement. It could be, the replacement water pump is faulty. Something is amiss and needs to be corrected before you go out and drive your vehicle. The noise could result into a catastrophic and an expensive repair. Second, no heat could be, there is air trapped in the heater core and needs to be bled and/or flushed. I recommend having your vehicle’s no heat and humming noise be diagnosed and repaired by a certified technician, such as one from YourMechanic.
Can a jeep run and drive without a water pump??
ANSWER : Driving or running the engine without the water pump working to circulate the coolant through the motor will cause the motor to overheat and may damage the engine costing thousands of dollars versus using a tow truck to take the vehicle to the shop that will cost a lot less. I would not recommend running the engine more than a few minutes at a time or you will overheat it.
My water pump is leaking but I replaced timing belt and pump a year ago. Can I just replace the water pump this time?
ANSWER : Hello. You can just replace the water pump in this case. Although, the cost of just the timing belt is fairly negligible in comparison to the total labor of the job. My estimator says the water pump is a 6.5 hour job. Multiply that by whatever the shop rate is and you have the total labor without parts. You end up saving about $100 or less on parts if you only replace the pump.
The deciding factor will be the condition of the timing belt. If it has problems, you won’t be saving yourself any money by reusing it. In addition, there are seals and pulleys that may need to be replaced as well.
Assuming all the related parts were replaced the first time around, there isn’t a reason you can’t reuse them. I would say you should weigh the savings of reusing them against the actual condition of the parts. This is best determined after a complete disassembly. Keep in mind, time estimates will vary a bit depending on many factors. Either way, the labor is the largest cost.
If you would like to have the water pump replaced, a certified professional from YourMechanic can come to your car’s location to perform this service at your convenience.
My engine blew out due to my water pump leaking…i didnt have no problems with my car over heating, no steam, running weird,
ANSWER : It is quite likely that when the car was hit, the radiator may have been punctured which would have caused a lot of the coolant to leak out of the vehicle.
If the water pump failed or if it were low on coolant, there would have been overheating indications on in the dash, so you should have had some kind of warning either way that the coolant level was low.
If you’d like to get this fixed, consider YourMechanic, as one of our mobile technicians can come diagnose the leak firsthand and help address any other potential issues.
Oil leaking from under car and "remote control car" sound when car is first started for a few minutes until it warm up.
ANSWER : Hello,
There are a number of things that could make an engine noisy when starting up. Depending on the specific type of sound you are referring to, this will determine how to properly diagnose. If there is a bit of a hissing sound, this may be a sign of a vacuum leak. If this is more of a shrieking sound, this may be a sign of a worn out or out of adjustment serpentine belt. If there is a bit of a howling or growling sound, this may be a sign of a worn out or low on fluid power steering pump. A rattling or pinging sound may be caused by an ignition problem. An engine can ping (or knock) due to an improper combustion process. A "spark knock" is the result of combustion occurring too early. Early combustion can occur from carbon buildup inside the combustion chamber, a lean air/fuel mixture, and advanced ignition timing (spark plug firing too soon). A clattering type sound may be a result of improper lubrication in the valve train which could be a more serious problem and should be addressed as soon as possible. I would suggest having an expert from YourMechanic come to your location to diagnose and inspect your vehicle to ensure everything is in proper working order.
There are a number of things that could make an engine noisy when starting up. Depending on the specific type of sound you are referring to, this will determine how to properly diagnose. If there is a bit of a hissing sound, this may be a sign of a vacuum leak. If this is more of a shrieking sound, this may be a sign of a worn out or out of adjustment serpentine belt. If there is a bit of a howling or growling sound, this may be a sign of a worn out or low on fluid power steering pump. A rattling or pinging sound may be caused by an ignition problem. An engine can ping (or knock) due to an improper combustion process. A "spark knock" is the result of combustion occurring too early. Early combustion can occur from carbon buildup inside the combustion chamber, a lean air/fuel mixture, and advanced ignition timing (spark plug firing too soon). A clattering type sound may be a result of improper lubrication in the valve train which could be a more serious problem and should be addressed as soon as possible. I would suggest having an expert from YourMechanic come to your location to diagnose and inspect your vehicle to ensure everything is in proper working order.
Fuel EVAP line that runs under car is kinked how do I know if it is leaking? Also can I drive it like that if it’s not leaking?
ANSWER : Hi Ricardo. We answered your question earlier. However, if you didn’t receive the reply, here is what we stated earlier. In most cases, an EVAP leak will create an OBD-II trouble code. The best way to detect an EVAP leak is by having a professional mobile mechanic complete a check engine light inspection, they will be able to download the code and determine the source of the leak. That’s the best advice we can offer you. Thanks.
Car makes grinding noise – 1996 Chevrolet Corsica
ANSWER : Hey there, thanks for writing in. I would have a professional mechanic check out the constant velocity joints on your vehicle. One or more of them may be worn enough to cause the noises you describe. S/he can diagnose and replace any failed CV joints.
