i was driving and my oil light kept going off. Car had oil. Car wouldn’t accelerate. Car died. It does not turn engine over now.

i was driving and my oil light kept going off. Car had oil and i topped it off. Car wouldn't accelerate. Car died. I heard some clanking noise before it died. It does not turn engine over now. Battery seems fine, all light still work.

My car has 225000 miles.
My car has an automatic transmission.

Experienced mechanics share their insights in answering this question :
It is very possible that the engine has been damaged beyond repair. Usually when the oil light goes on and the vehicle is low on oil, especially when a loud noise is heard right before the vehicle died, it is very likely that the engine is blown and would require replacement in order to continue driving the vehicle. I would recommend having the vehicle checked with a no start inspection. Consider YourMechanic as this service can be completed at your home or office.

How to Identify and Fix Common car Problems ?

Our sources include academic articles, blog posts, and personal essays from experienced mechanics :

If the engine oil light still comes on and makes the engine stall out with a strange noise, then the oil pump has failed or the oil pump pick up tube has become clogged and will not pick up any oil. To verify this, you would need hook up an oil pressure gauge to a port on the engine near the oil filter.
Many modern vehicles are designed with several fail-safes to help protect the engine in adverse conditions. One of this is an automatic shutoff when the oil pressure drops to a certain level, or the oil level drops too low (note that this is not true for all cars). This causes the engine to stall and die.
The presence of oil and its distribution is absolutely crucial to an engines continued operation. Engines can work without oil, but the effect is so damaging they are only capable of running for less than 30 minutes until failing – and in most cases, it`s a lot quicker than that.
Chances are your engine is low on oil. When hitting brakes oil flows forward and away from sensor which can show low oil level or pressure. When you come to stop or accelerate, oil flows back to a level that is acceptable to the sensor and light goes out. Check your oil level!
When the engine breaks down due to low oil levels, very costly repairs are in store. Low oil levels cause valves to burn up, seals to dry out, and internal parts to heat up and eventually deform or break. Until something breaks, the engine will continue to lose power and burn more fuel while running poorly.
Loud popping, knocking, and stuttering noises from the hood of your vehicle are cause for concern, and could be a sign of major engine damage.
The short answer is yes. Engine oil is crucial in maintaining optimal performance by lubricating and cooling engine components. Neglecting regular oil changes can lead to increased friction, reduced efficiency, and potential engine damage, ultimately impacting acceleration.
Should your vehicle`s engine run low on engine oil it could cause it to make a loud “ticking or tapping” noise. This noise is caused by an insufficient amount oil being pumped into the top part of the engine. A simple check of the engine oil level will help you determine if the system is low.
Topping up your oil is typically not recommended unless the level is below the minimum mark. If you`re running low on oil, however, topping off may help you get to your nearest Firestone Complete Auto Care for an oil change service.
Driving isn`t recommended when you have a bad oil pressure sensor. You shouldn`t take it lightly, even if you`re confident it`s just an oil pressure sensor problem. Maintaining the correct oil pressure in your engine is critical to keep it functioning. A bad oil pressure sensor can give the wrong oil pressure readings.
You shouldn`t drive with a failing oil pump for too long or you will risk damaging the crankshaft and the camshaft bearings. Additionally, driving with a bad oil pump implies a lack of lubrication which could damage the car`s hydraulic lifters.
When the oil warning light comes on, it is a sign that the engine oil pressure has dropped to a low level, which is dangerous. An engine running with low oil pressure can quickly destroy the engine.

Relevant Questions and Answers :

the most relevant questions and answers related to your specific issue

i was driving and my oil light kept going off. Car had oil. Car wouldn’t accelerate. Car died. It does not turn engine over now.
ANSWER : It is very possible that the engine has been damaged beyond repair. Usually when the oil light goes on and the vehicle is low on oil, especially when a loud noise is heard right before the vehicle died, it is very likely that the engine is blown and would require replacement in order to continue driving the vehicle. I would recommend having the vehicle checked with a no start inspection. Consider YourMechanic as this service can be completed at your home or office.

Was driving on the expressway and my car started shaking, check engine light turned on, oil light turned on and off
ANSWER : Hello, thank you for writing in. Shaking and vibrating typically comes from a misfire, or poor engine performance. A lack of oil will absolutely contribute to these symptoms and amplify them, if not cause them to begin with. You want to turn your attention to the cause of the oil leak. If external (you can see the leaking oil), then you will want to trace the leak to the component which has failed. If the leak is internal (or the engine is consuming oil), the leak will be harder to find. It will also explain the poor engine performance due to excess oil in the combustion chamber. A head gasket is one of the main components that will fail and cause these issues. It is however not common for a vehicle this age to have these kinds of problems. You will also want to scan the computer, and see what codes are triggering your check engine light. These diagnostic tools will help you determine what system(s) is to blame for the malfunction. For more diagnostic help, contact our service department to schedule an appointment.

Check engine light refuses to go off after engine replaced
ANSWER : Hello there, you have a long series of issues going on with your 2013 Hyundai Sonata. If you keep getting a repeating oil light on than there is likely a fault in that system.

Since this fault has lasted after the engine was replaced it could be a oil pressure sensor, wiring harness fault, ECU fault, oil pump, oil strainer clogged, or low oil pressure.

To diagnose this issue properly you need a complete vehicle inspection to start from square one and identify the root cause of all this.

Battery and oil light come on when trying to start car, take keys out try again car starts no problem and lights go away
ANSWER : Of course, don’t switch gears without being fully stopped, unless your Owner’s Manual or the manufacturer has alternative advice. However, the gear shift issue has no relation to the no-start problem you are describing. Inasmuch as you only have 6,000 miles on the car, the "constant on and off" that you believe has occurred is meaningless in comparison to the expected total vehicle service life. That is, assume what you perceive as "constant on and off", during merely 6,000 miles, might be equivalent to using the car "normally" for three years. A new car should be trouble free for at least 5 years, unless there is a defect, so your "constant on and off" is not a causal factor for any fault on the vehicle. What you might have is a defect in the ignition switch, or perhaps the immobilizer system, but if the problem is not in the switch itself, clearly there is an electrical problem.

If your vehicle is under warranty, by law the dealer MUST repair the issue you are describing within a prescribed time frame and number of "attempts", otherwise the dealer will run afoul of Federal and state Lemon Laws that give you very specific rights, and recourse (contact an Attorney; we are Mechanics, NOT attorneys). Consequently, if the vehicle is still under warranty, to save yourself money do be sure to seek a resolution from the dealer. If the vehicle is not under warranty, obviously a certified Mechanic from YourMechanic could identify the electrical fault and resolve this for you. If you want to go that route, please simply request a no start diagnostic -electrical system and the responding certified mechanic will get this taken care of for you. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

Car started to slow down and then the check engine light, battery, and engine oil light came on. What could cause this?
ANSWER : Hi there. It is possible that the battery cable came loose or the wires to the oil pressure sensor has came loose or failed. Check the battery cables and make sure that the terminals are tight and clean. Check the wires to the oil pressure sensor and make sure that they are connected and not broken. If everything looks good, then the oil pressure sensor may have failed. Plus, check the computer for codes and see what is stored. This will lead you to the part that could have failed. I recommend replacing the oil pressure sensor then checking to see if the lights will go out. If you need further assistance troubleshooting your vehicle, then seek out a technician, such as one from Your Mechanic, that can assist you with the warning lights that came on.

Battery light goes on when I start car then turns off, if I rev engine light comes back until rpms go down. Abs goes comes on/off
ANSWER : Batteries can die due to faults in the charging system so ideally a suspected "faulty" battery should be load tested before a decision is made to condemn it. The only exception to this rule is if the battery is already clearly "old" (greater than 5 years) but even then once you put a new battery in, as a replacement for a "dead" battery, you have to comprehensively check out the charging system. Diagnostic Trouble Code P0460 will result in disruption of the dashboard fuel gauge’s ability to accurately report your tank’s fuel levels. The fuel gauge readings may be erratic, or read somewhere off scale. Vehicles equipped with a low fuel warning light feature may also suffer from erratic low fuel warnings in the event of a code P0460. Unless the P0460 code has been reported alongside other trouble code, all of the vehicle’s essential systems should otherwise function normally. I would recommend that you request a check engine light diagnostic to first resolve the fault causing the P0460 code to set. The check gas cap light warning light could be due a faulty gas cap and/or small leaks in the EVAP system.

My car stalls at times, yesterday the car shut off at a red light. I turned car off then back on now engine light is on.
ANSWER : This may be a result of a dirty or failing idle air control valve. The idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle. Since this valve is controlled by the vehicle’s computer, it will adjust idle speed based upon other measurements such as engine temperature, intake air temperature and electrical system load or voltage. When you accelerate, the engine RPM increases, and as you let off the gas, the RPM slowly returns to the normal idling speed with the help of the idle air control valve making the transition from a higher RPM back down to idle speed. When the engine RPM drops below the normal range of about ~800 RPM, this often times will cause the engine to stall indicating a dirty or faulty idle air control valve. I would recommend having an expert from YourMechanic come to your location to diagnose and replace your idle air control valve.

think i put wrong oil in car went few miles lose power car dies oil in spark plugs still starts low oil blinking light before die.
ANSWER : Hello. If you put too thick of an oil in the car, then you may have damaged the engine bearings but this should not have caused oil to get in to the spark plugs unless the oil got into the intake of the engine or one of the pistons rings broke. If you ran it without oil and then tried to put oil in thinking it would be okay after that, then you were not that lucky and broke or damaged all of the rings on the pistons. If you would like to have this looked over, a certified professional from YourMechanic can come to your car’s location to inspect the stalling issue and go over all of the relevant systems for a better diagnosis.