Supportive bar attached to brake pedal interrupts proper braking process

ANSWER : It’s possible to have someone alter the brake pedal or adapt a brake pedal from a different vehicle. You may call around to some customization shops to see if anyone is interested in taking on the project. But first, I would try reaching out to the selling dealer with your concern – especially since it is a new model. Good luck.

ANSWER : The brake pedal is working to stop the vehicle, but there may be air in the controller unit causing the ABS brakes to not function. I recommend bleeding the brake system from the farthest location from the master cylinder to the master cylinder including the ABS unit. If the brakes are still spongy after a full bleed, then the controller will need to be replaced. If you need further assistance with your brake pedal being spongy, then seek out a professional, such as one from Your Mechanic, to help you.

ANSWER : Hi there – your brake light switch needs a minor adjustment. It is adjusted too "tight" or close to the brake pedal lever, or possibly has failed. Adjusting/replacing it will eliminate this flickering problem. I recommend a brake light isn’t working inspection performed by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose this problem, and give you an accurate assessment of damage and cost estimate for repairs.

ANSWER : Hi. I will help you with this issue you are having with your 2001 Durango. Unless you bled the master cylinder, it is possible there is still air in the system. If you car is equipped with ABS, air could have also gotten trapped in the ABS modulator. If ABS equipped, a bi-directional scan tool would be essential to manually activate the ABS system to clear air from that segment of the lines while you are bleeding the system. It is also possible that in all of this work somehow the proportioning valve has been affected causing the desired pressure differential, front versus back, to get out of spec. Using a 2,500 PSI gauge, you can check the pressures at each wheel and that will definitely give you a clue as to which brake circuit is the issue (or both), whether the proportioning valve is working properly and whether the line pressures at each wheel are within spec. Should you need a second opinion, by all means feel free to contact YourMechanic for assistance and we will diagnose and repair the issue for you.

ANSWER : Hi there. Typically, when a brake booster fails, the result is a hard to push brake pedal. The pressure release you hear is engine vacuum and may be normal considering, the brake pedal travels to the floor. With no apparent leak(s) in the hydraulic braking system, the master cylinder internally bypassing is the most common failure. Having replaced the master cylinder, this leads me to believe, there may be air trapped and a flush may resolve this concern. Assuming, the vehicle is equipped with ABS (anti-lock brake system). The ABS hydraulic modulator assembly may be internally bypassing. I recommend having your vehicle’s brake pedal issue diagnosed and repaired by a certified technician, such as one from YourMechanic.

ANSWER : Hi there. The first thing that pops in my mind beyond of what you have listed is perhaps the electrical harness attached to the brake switch. Perhaps the harness itself is damaged or you have an exposed wire, loose ground wire somewhere. You might want to have a professional mobile mechanic come to your location and complete a brake lights not working inspection to help you diagnose this issue.

ANSWER : If you are having to refill the brake fluid from it getting low and the brakes go to the floor means you have a leak in the brake system somewhere. You may have a broken brake line, leaking wheel cylinder or caliper. You should not drive the vehicle until the brake system is inspected and repaired from the leak.

ANSWER : You will have to bleed the brakes from the farthest location all the way to the master cylinder. There is still air in the lines causing the issue. Check the vibrations on the vehicle to see if the engine mounts are damaged or if the brakes are not releasing causing the engine to run harder than normal to overcome the braking force. If you need further assistance with your vehicle’s brake system, then seek out a professional, such as one from Your Mechanic, to help you.