High idle after replacing fuel pump tps and air idle control valve

ANSWER : The first thing to do is to verify there are no vacuum leaks in the engine and verify the installation of the parts. Once this is done then disconnect the battery and then let sit for two minutes and reconnect battery and relearn the idles by starting the vehicle and putting in drive after it warms up for two minutes with a/c off and then two minutes with a/c on and then road test normally to verify ides good.

ANSWER : Hi there. This can be caused by the issues that you mentioned or a number of other things. You need to make sure all of the connectors are making good contact. I would then need to know what codes are in the computer to know if this is a circuit issue or not. Most of the time, it is not the circuit but instead a vacuum leak.

If there is a vacuum leak, then the vehicle will act like this and the computer cannot control the idle. Most of the time it is a bad hose or an EGR valve that is stuck open. That is the most common cause for this. I typically remove the EGR to check it to feel the diaphragm on the bottom of it to see if it is moving correctly. If you need to have this repaired, consider YourMechanic, as a certified mechanic can come to your home or office to diagnose and repair your car’s idling issue.

ANSWER : You need to look at the theft light on dash to make sure it comes on and goes off when you turn the key to the on position. If light comes on and stays on then your theft system is causing the fuel pump to not be engaged. I recommend you check the theft system and then scan the computer for theft system codes. You may need to reprogram the keys to work or you have an bad sensor for the ignition key in the steering column.

ANSWER : Hi there – the metal component you describe is a fuel check valve on the fuel return line. Its function is to maintain a small amount of pressure in the fuel system so that starting does not require the fuel pump to run very long before the engine will start. Having replaced the fuel pump and fuel filter, I would check fuel pressure while the car is running. This is to check the fuel pump relay for burned contacts that won’t support full electrical current to the pump, and for proper fuel pressure – a malfunctioning fuel pressure regulator could also restrict power and higher speeds if pressure is too low. I would recommend an inspection of the fuel system by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose this problem, give you an accurate assessment of damage and cost estimate for repairs.

ANSWER : If air is getting to the valve but not coming out, odds are yes the valve is bad. Unfortunately there is no rebuilding kit for them. It most likely will have to be replaced then the entire system will need to be checked for any other leaks or faults.

ANSWER : Hi there – I suspect you have weak power getting to the fuel pump. I would first check the voltage coming out of the fuel pump relay. If the contacts in the relay are burned, you will not get reliable current flow to the pump. Check the fuel pump ground as well (voltage drop across the ground, not just continuity). I recommend a fuel system inspection performed by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose this problem, give you an accurate assessment of damage and cost estimate for repairs.

ANSWER : Hi there. There could be multiple issues causing your lack of spark problem, ranging from a minor electrical short in the main relay to an issue with your ECU. In order to know for sure, you should have a professional mobile mechanic complete an electrical problems inspection.

ANSWER : Hello,
You may want to try checking the fuel pump relay. The relay wires should have ground on two wires, power on one wire and switched power on another wire. To activate the fuel pump your ECU actually connects one of the ground wires to complete the circuit and send power to the fuel pump. If the wires all have power running through them, then it is likely you have a faulty relay. The wire coming from the fuel pump is the other ground wire. I would recommend having an expert from YourMechanic come to your location to diagnose your wiring as this can be very difficult and time consuming without the proper wiring diagram.